Make sure that your TV set is correctly connected to your DVD recorder.After installing the update you will need to reconfigure your recorder. Your DVD recorder will be reset to the factory default settings.Please remove anything that could potentially obstruct the disc tray before updating. The disc tray will automatically open during update.First read the whole procedure before starting to update the firmware of your recorder. The firmware update process may take approximately 8 minutes.Doing so may damage your recorder and make it unusable, and would require a repair of DVD recorder. Do not press any button, except as instructed, until the update is complete.Do not turn off the DVD recorder or disconnect the DVD recorder from the power supply during the update process.Do not create the update disc using another process than the one described above.(Packet writing is an optical disc recording technology used to allow writeable CD and DVD media to be used in a similar manner to a floppy disk). Burning the update disc using a packet writing software is not supported.In case of doubt, recreate a new update disc. Make sure the disc creation was correctly done without any error.Make sure that the disc session is closed / the disc is finalized.
Burn the update file onto a new blank CD-R disc or completely erased CD-RW disc using disc-at-once mode and ISO 9660 CD-ROM file system format. To do so, right click the file, select "properties" and check that the "General" tab displays the following size information: If the size information displayed on your computer is different, delete the downloaded file, clear your internet browser's cache and download it again. When the update is complete, check that the file is 14,845,952 bytes. After you have accepted the disclaimer, save the update file to your computer Desktop. Failure to follow the instructions may cause the DVD recorder to be unresponsive or to require repair. Please read all the information carefully and thoroughly before downloading and installing any file. You need to accept the disclaimer below before downloading the file. If the version number is 1.70 or higher, your DVD recorder does not need to be updated. The firmware version currently installed on the DVD recorder will be listed on the television screen as VERSION. Highlight Dolby Digital and press the ANGLE button. 
On the remote control, press the SYSTEM MENU button. Power on the television and make sure it is tuned to the inputs to which the DVD recorder is connected. You need a computer with a CD-R or CD-RW writer with burning software. The recorder may not be able to correctly read a dirty disc or a disc with scratches. Use a good quality branded blank CD-R disc or completely erased CD-RW disc to burn the firmware update.
0 kommentar(er)
